Category: Radio Resource Management
E2SM RC – E2 Service Model RAN Control Procedure
Introduction In our other post Open RAN E2 Interface , we discussed that E2 is the interface between the Near RT RIC and Open RAN CU/DUs. This interface uses following […]
5G NR Resource Allocation – Resource Allocation Type 0
Introduction To transmit and recieved data in downlink and uplink UEs need bandwidth resource allocated and this allocation provided by gNB. In 5G NR, similar to 4G the resource allocation […]
5G NR Measurement Configuration: Meas Object, Report Config, Meas ID
During UE attach, after a radio bearer is set up, the eNB (in NSA Mode) or gNB (in SA Mode) delivers measurement configurations to the UE based on the mobility […]
5G NR RSRP Measurement Report Mapping
In 5G NR, RSRP measurement is performed and reported at Layer 1 (Physical Layer) and Layer 3 (RRC Layer). For example, 5G capable device can provide SS-RSRP measurements at Layer […]
5G NR RRC Timers, Counters and Constants
5G NR radio resource control (RRC) has introduced following listed timers, counters and constant for reliable functioning of procedures like RRCsetuprequest, RRCreestablishment, RRCresume, RRCsuspend etc. RRC timer indicates the timer […]
5G NR RRM Measurement Requirements
In 5G NR, the Sync Signal/PBCH block (SSB) burst is consists of multiple SSBs. These multiple SSBs are associated with the different SSB indexes and with the different transmission beams […]